the best thing about them is sound quality and build quality..
but why the hell when cued it shows like 0db bet when it goes to master it shows like -3? mixing with faders crossfader at center with normal curve
EQ Tips & Tricks
i discovered a trick to hear the post-eq signal while cueing.
what you have to do is set the cue signal to aux (the botton below
the cue volume) and press down the buttons labelled "pre" under each
channel's aux pot. then, use the aux pots to send the signal to your
headphones. of course, you have to have the cue buttons de-activated.
hope that helps.
unfortunately, this still does not allow you to hear the post-filter signal
while cueing.
what you have to do is set the cue signal to aux (the botton below
the cue volume) and press down the buttons labelled "pre" under each
channel's aux pot. then, use the aux pots to send the signal to your
headphones. of course, you have to have the cue buttons de-activated.
hope that helps.
unfortunately, this still does not allow you to hear the post-filter signal
while cueing.
-
- mnml newbie
- Posts: 97
- Joined: Mon Nov 10, 2008 3:09 pm
- Location: Belgium
we are playing with an xone 92, those 4 band are much more fun to play than for example with a pioneer djm800 .. i don't understand why a lot of mixers stick with this 3 band eq, its annoying. like themis wrote the low freq pulled down can do nice things, than plus filter omg i can keep myselves buisy with this for days :-)
lessizmoremoreizless